This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1659
Hantek P2301B 300MHz 100M Oscilloscope Probe BNC Protective Cap Scope Clip Probe
New
R776.00
Closed
11 May 24 00:02
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
612362399
Features: ? 1. The main body is grounded, which is smoother and reliable. 2. The probe is fully grounded in the form of injection molding, which greatly increases the service life of the grounding wire. 3. BNC (Q9) material, equipped with an insulating sheath on the outside of the BNC, which improves the safety level. 4. The probe is commonly used in oscilloscopes on the BNC interface on the market.
Specification: ? Product model: P2300B Product Name: Oscilloscope Probe Product weight: 0.075kg Bandwidth: 1-300MHz Maximum input voltage: 600V Attenuation ratio: 100X Input resistance: 100M??
NOTE:
When connecting the probe to any input channel for the first time, a probe check is required to match the probe to the input channel. Probes that are not compensated or compensated for deviations can cause measurement errors or errors. 1. Set the software selection X10. Set the probe attenuation factor X10 and connect the probe to the CH1 channel. If using a hook probe, make sure the probe is in close contact with CH1. Connect the probe tip to the signal output connector of the probe compensator, and the reference lead clip is connected to the ground connector of the probe compensator. 2. Check the shape of the displayed waveform to determine if the probe compensation is correct, turn on CH1, and press the a??AUTOa?? button. 3. Check the shape of the displayed waveform to determine if the probe compensation is correct.
Package?includes:
1 X?P2300B?Oscilloscope Probe
Details?pictures:?
Specification: ? Product model: P2300B Product Name: Oscilloscope Probe Product weight: 0.075kg Bandwidth: 1-300MHz Maximum input voltage: 600V Attenuation ratio: 100X Input resistance: 100M??
NOTE:
When connecting the probe to any input channel for the first time, a probe check is required to match the probe to the input channel. Probes that are not compensated or compensated for deviations can cause measurement errors or errors. 1. Set the software selection X10. Set the probe attenuation factor X10 and connect the probe to the CH1 channel. If using a hook probe, make sure the probe is in close contact with CH1. Connect the probe tip to the signal output connector of the probe compensator, and the reference lead clip is connected to the ground connector of the probe compensator. 2. Check the shape of the displayed waveform to determine if the probe compensation is correct, turn on CH1, and press the a??AUTOa?? button. 3. Check the shape of the displayed waveform to determine if the probe compensation is correct.
Package?includes:
1 X?P2300B?Oscilloscope Probe
Details?pictures:?