Heat sink Plaster (Thermal Conductive Adhesive) 0.5 Gram **IN STOCK**

Used for CPU cooler ,led light and other electronics parts .

White thermal glue/plaster, the thermal conductivity is 0.975W/m-k

*The Dielectric constant is very high, can withstand voltages above 10 000 volts.

*Low thermal impedance, it can endure paste state.

*Wide Operation temperature range, can keep stable performance between -55~300°C.

*High heat dissipation performance, have Cost-effective.

*5G Tube

Apply a thin layer to the heat sink. Push firmly down the LED in place on the heat sink allowing excess plaster to escape out around the edge of led, don't let the glue cover the soldering pad. The closer the led is to the heat sink, the better the cooling. Leave the LED for the glue to cure. When finished, please cover the tube nozzle with layer of plastic film before turning the cap back to ensure air does not get to the plaster. A small amount of air will solidify the plaster in the tube