Similar products

Corsair XTM70 thermal paste

Platinum Selection

R510.00

Syringe Curved Pointed Tip 12ml for Thermal Paste or Flux DIY **LOCAL STOCK**

Diy Select - Cape Town

R20.00

Glue Sticks

Gadgetgyz

R7.43

Thermal Paste Grey GD900 Soft Pack Sachet 0.5g (4.8 W/MK) **LOCAL STOCK**

Diy Select - Cape Town

R6.50

Sold

Heatsink Thermal Paste Plaster Glue + Applicator Stick IN STOCK

Name: Heatsink Thermal Paste Plaster Glue + Applicator Stick **IN STOCK**
SKU: HEA150/HEA155
Price: 29.00 ZAR
Availability: SoldOut
Rating: 5 (2 reviews)

10 were available / new

R29.00

Shipping

R65.00 Standard shipping applies to orders under R100.00, in most areas in South Africa. R35.00 Standard shipping applies to orders over R100.00. Some areas may attract a surcharge surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller allows collection for this item. Buyers will receive the collection address and time once the order is ready.

The seller has indicated that they will usually have this item ready to ship within 2 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

Led Select - Cape Town29868

100.00 % Positive ratings

Buyer protection

How you're covered

Get it now, pay later

Product details

Condition

New

Location

South Africa

Customer ratings:

2 ratings

Product code

HEA150/HEA155

Bob Shop ID

307627824

Heatsink Plaster (Thermal Conductive Adhesive) 0.5 gram:

+ Applicator Stick

Heat-sink Adhesive Plaster is a Thermal Conductive Paste & Adhesive for fixing/Glueing 1W-100W Leds to Heat-sink.

Fixing led star bases to larger Aluminium cooling plate providing effective heat dissipation.

Thermal conductivity: >0.671 W/m-k
Thermal Resistance: <0.06 °C-in2/W

Instructions:

Apply a thin layer to the underside of your led. Push firmly down in place on the heatsink allowing excess plaster to escape out around the edge of led. The closer the led is to the heatsink, the better the cooling. Connect your driver and allow the led to shine and create heat to cure the plaster for 20 - 30minutes or until you cannot move the led. (When finished, please cover the tube nozzle with layer of plastic film before turning the cap back to ensure air does not get to the plaster. A small amount of air will solidify the plaster in the tube)