Similar products

10cc Empty Syringe for Solder Paste / Solder Flux / Glue **LOCAL STOCK**

Diy Select - Cape Town

R42.00

Corsair XTM60 High Performance Thermal Paste; 3g

Platinum Selection

R280.00

PCBuilder Nanometer Thermal Paste 4g Conductivity 5.15W/mK

Gadgetgyz

R53.90

Solder Paste XD-50 Tub **LOCAL STOCK**

Diy Select - Cape Town

R149.00

Sold

Heatsink Thermal Paste Plaster Glue IN STOCK

Name: Heatsink Thermal Paste Plaster Glue **IN STOCK**
SKU: HEA150
Price: 19.00 ZAR
Availability: SoldOut
Rating: 5 (1 reviews)

36 were available / new

R19.00

Shipping

R65.00 Standard shipping applies to orders under R100.00, in most areas in South Africa. R35.00 Standard shipping applies to orders over R100.00. Some areas may attract a surcharge surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller allows collection for this item. Buyers will receive the collection address and time once the order is ready.

The seller has indicated that they will usually have this item ready to ship within 2 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

Led Select - Cape Town29868

100.00 % Positive ratings

Buyer protection

How you're covered

Get it now, pay later

Product details

Condition

New

Location

South Africa

Customer ratings:

1 ratings

Product code

HEA150

Bob Shop ID

384832281

Heat sink Plaster (Thermal Conductive Adhesive) 0.5 gram:

Heat-sink Adhesive Plaster is a Thermal Conductive Paste & Adhesive for fixing/Glueing 1W-100W Leds to Heat-sink.

Fixing led star bases to larger Aluminium cooling plate providing effective heat dissipation.

Thermal conductivity: >0.671 W/m-k
Thermal Resistance: <0.06 °C-in2/W

Instructions:

Apply a thin layer to the underside of your led. Push firmly down in place on the heatsink allowing excess plaster to escape out around the edge of led. The closer the led is to the heatsink, the better the cooling. Connect your driver and allow the led to shine and create heat to cure the plaster for 10 - 30minutes or until you cannot move the led. (When finished, please cover the tube nozzle with layer of plastic film before turning the cap back to ensure air does not get to the plaster. A small amount of air will solidify the plaster in the tube)