Similar products

Glue Stick Black 200mm x 11mm Dia **LOCAL STOCK**

Diy Select - Cape Town

R36.00

Glue Sticks

Gadgetgyz

R7.43

Thermal Paste Spatula Applicator Stick (White) **LOCAL STOCK**

Diy Select - Cape Town

R6.00

Heatsink Thermal Paste GD-2 Syringe 3g Grey (7.5W/MK) **LOCAL STOCK**

Diy Select - Cape Town

R55.00

Sold

Heatsink Thermal Plaster Glue + Applicator Stick LOCAL STOCK

Name: Heatsink Thermal Plaster Glue + Applicator Stick **LOCAL STOCK**
SKU: HEA150/HEA160
Price: 23.00 ZAR
Availability: SoldOut
Rating: 5 (4 reviews)

10 were available / new

R23.00

Shipping

R65.00 Standard shipping applies to orders under R100.00, in most areas in South Africa. R35.00 Standard shipping applies to orders over R100.00. Some areas may attract a surcharge surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller allows collection for this item. Buyers will receive the collection address and time once the order is ready.

The seller has indicated that they will usually have this item ready to ship within 2 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

Led Select - Cape Town29868

100.00 % Positive ratings

Buyer protection

How you're covered

Get it now, pay later

Product details

Condition

New

Location

South Africa

Customer ratings:

4 ratings

Product code

HEA150/HEA160

Bob Shop ID

436884065

Heat sink Plaster (Thermal Conductive Adhesive) 0.5 Gram:

Category: 1900312645 - Heatsink + Thermal

Specifications:

Thermal conductivity: >0.671 W/m-k
Thermal Resistance: <0.06 °C-in2/W
Weight: 0.5g

Heatsink adhesive plaster is a thermal conductive paste & adhesive for fixing / glueing 1W-100W led base plate to heatsink.

Instructions:

Apply a thin layer to the underside of your led Base. Push firmly down in place on the heatsink allowing excess plaster to escape out around the edge of led. The closer the led is to the heatsink, the better the cooling. Connect your driver and allow the led to shine and create heat to cure the plaster for 10 - 30minutes or until you cannot move the led. (When finished, please cover the tube nozzle with layer of plastic film before turning the cap back to ensure air does not get to the plaster. A small amount of air will solidify the plaster in the tube)

* Includes Applicator Stick!