Name: Heatsink Thermal Plaster Glue **LOCAL STOCK**
SKU: HEA150
Price: 14.70 ZAR
Availability: SoldOut
Rating: 5 (3 reviews)

Heatsink Thermal Plaster Glue **LOCAL STOCK**

107 were available / new

R14.70

Shipping

R65.00 Standard shipping applies to orders under R100.00, in most areas in South Africa. R35.00 Standard shipping applies to orders over R100.00. Some areas may attract a surcharge surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller allows collection for this item. Buyers will receive the collection address and time once the order is ready.

The seller has indicated that they will usually have this item ready to ship within 2 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

Led Select - Cape Town29868

100.00 % Positive ratings

Buyer protection

How you're covered

Get it now, pay later

Condition

New

Location

South Africa

Customer ratings:

3 ratings

Product code

HEA150

Bob Shop ID

433595849

Heat sink Plaster (Thermal Conductive Adhesive) 0.5 Gram:

Category: 1900312645 - Heatsink + Thermal

Specifications:

Thermal Conductivity: >0.671 W/m-k
Thermal Resistance: <0.06 °C-in2/W
Weight: 0.5g

Heatsink adhesive plaster is a thermal conductive paste & adhesive for fixing/glueing 1W-100W leds to heatsink.

Also used for fixing of led star bases to larger aluminium cooling plate, providing effective heat dissipation.

Instructions:

Apply a very thin layer to the underside of your led. Push firmly down in place on the heatsink allowing excess plaster to escape out around the edge of led. The closer the led is to the heatsink, the better the cooling. Connect your driver and allow the led to shine and create heat to cure the plaster for 10 - 30minutes or until you cannot move the led. (When finished, please cover the tube nozzle with layer of plastic film before turning the cap back to ensure air does not get to the plaster. A small amount of air will solidify the plaster in the tube)