This item has closed 1 buyer bought 4 items
View other items offered by XT Comp10348

Similar products

Power Supply 12V 1.5A 18W Water Resistant **LOCAL STOCK**
New
R115.00
Tool Gripper Claw Pen for IC, Chip, SMD, Screws **LOCAL STOCK**
New
R60.00
20W Led Warm White Smart IC Direct 220V **LOCAL STOCK**
New
R60.00
50W Led White Smart IC Direct 220V **LOCAL STOCK**
New
R65.00
HT12E Encoder 18 DIP IC ***LOCAL STOCK***
Sold

HT12E Encoder 18 DIP IC ***LOCAL STOCK***

New 66 were available
R11.80
Shipping
R65.00 Standard shipping applies to orders under R100.00, in most areas in South Africa. R35.00 Standard shipping applies to orders over R100.00. Some areas may attract a surcharge surcharge. This will be calculated at checkout if applicable.
Check my rate
The seller has indicated that they will usually have this item ready to ship within 5 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:
 
Standard Delivery
Main centres:  1-3 business days
Regional areas: 3-4 business days
Remote areas: 3-5 business days
Buyer protection
Get it now, pay later

Product details

Condition
New
Location
South Africa
Bob Shop ID
395065925

HT12E Encoder 18 DIP IC

HT12E Encoder IC is a 212 Series Encoder. It’s used in RF applications and remote control applications. Encoder and Decoder paired. This combination is useful for data transmission and able to receive 12 bits of parallel data serially. HT12E Encoder used to convert 12 bit parallel data into a serial output. The data transmitted through an RF transmitter. This 12-bit data is split into address pins (8) and data pins(4). These 8 address pins provide security code for data transmission and different receivers addressed with the same transmitter.

HT12E Encoder IC main function is to convert parallel data into serial data. It encodes the given input data and sends the output from the output pin. This output data sent to the decoder and after that data transferred. This has an inbuilt Crystal oscillator helpful for data transmission. This IC works “5 V” but operates in wide range voltage from 2.4 V -12 V. The supply pin connected with “5 V” and ground pin to ground. The data transmission will begin if the Transmission Enable pin connected to ground. For decoding a data, we require an oscillator. The oscillator connected with a resistor “1 M” ohm in 15th & 16th pin. The data has to be sent through AD0 to AD1. The address of these pins has to be set from A0 – A7. The decoder should have the same address as of the encoder so that data transmission will occur.

The HT12E Encoder IC starts working by giving enable signal to the Transmission Enable pin. The 4-word data encoded until the TE pin enabled. The output produced when the enable pin goes to HIGH. This encoder is in a standby state until the output encoding.


    Used for converting Parallel to serial data.
    Wireless communication application involving RF.
    Used in Home automation for remote switching.
    Burglars alarm system, Fire alarm etc.
    Garage doors, Car alarm system, Car door controls etc.

This item is available in stock and is not drop shipped. This avoids delays, customs charges and extra VAT.

Recently viewed

See more
Linkbasic UTP Cable Tester
New
R169.60
ACEFAST Charging Data Cable C7-03 USB-C to USB-C 100W
New
R208.95
Manhattan Internet Radio stick
New
R174.00
51% OFF
Full Colors Rotating Disco Party Light
New
R99.00 R200.00