This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1914
Similar products
JDY-22 4.2 Ultra Low Power BLE bluetooth Module Serial Transmissions External Antenna
New
R400.00
Closed
9 Jun 24 23:04
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 12 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
615100135
JDY-22 sleep pattern description:
?
Common problem description:
Default parameter configuration used in factory:
?
Package?included:
1 x JDY-22 4.2 Ultra Low Power BLE bluetooth Module Serial Transmissions External Antenna
| Sleep pattern | Instructions | Functional description |
| Start wake-up | AT+STARTEN1 | Mode 1: wake up call, users need sleep can be controlled by AT+SLEEP command, wake up can be awakened by PWRC pin low level. |
| Start sleep | AT+STARTENO | Mode 0: the power is very low under?this mode.?The connection calls the permeable transmission current at 900uA, disconnects the connection current below 200uA (can set the broadcast interval current to 30uA), this mode PWRC pin wake up, such as the serial port in 10 seconds without data or will not be connected to sleep automatically again into sleep |
Common problem description:
| Problem | Answer to the question |
| 1: how?MCU disconnects the bluetooth connection in the connection state | In the connection state, the PWRC pin is pulled down, and the serial port sends AT+DISC to disconnect. |
| 2: how much is the current when the module wakes up | All mode work current is not more than 1mA |
| 3: How much data can be written to serial port once | No byte limit at 9600 baud rate |
| 4: After the?serial port is configured, do you need to restart it to take effect? | It is recommended to restart the module when the parameters are set |
| 5: How to test the depth of sleep current in the test module | It is recommended to test the current of VCC and GND pins |
Default parameter configuration used in factory:
?
| Sequence | Function | Factory default parameters | Instructions |
| 1 | Serial port baud rate | 9600 | AT+BAUD4 |
| 2 | Sleep pattern | Start wake-up | AT+STARTEN0 |
| 3 | Broadcast name | JDY-21 | AT+NAMHJDY-21 |
| 4 | Broadcast interval | 200MS | AT+ADVIN1 |
Package?included:
1 x JDY-22 4.2 Ultra Low Power BLE bluetooth Module Serial Transmissions External Antenna