Jonsbo M.2-3 Solid State Radiator For NVME/SSD(Grey)
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
TBD0595287301B
Bob Shop ID
614999823
Jonsbo M.2-3 Solid State Radiator For NVME/SSD(Grey)
1. Material: aluminum
2. Heat dissipation method: drainage passive heat dissipation
3. With high-quality thermal silica gel, quickly conduct heat to avoid overheating and slowing down
4. Suitable for M.2 2280g solid state drive
5. Anode sandblasting process, anti-corrosion and anti-rust, not easy to get dirty
6. Diversion type upper heat sink, solid state drive (not included)
7. The heat sink under the shell, the overall heat dissipation effect is good
8. Striped lines at the bottom increase the heat dissipation area and quickly take away heat
9. Dimensions: 24.4x7.3x6.9 cm
10. Weight: about 80 grams
installation steps:
1. Tear off the thermal pad film and stick it in the bottom card slot
2. Put the SSD PCB into the card slot with the chip facing up
3. Adjust the position of the PCB to reveal the golden fingers and screw holes
4. Stick a thermal pad on the inside of the top fin (tear off the film)
5. After jamming one side of the card slot, press to fix it
6. If you need to disassemble, slide your fingernail along the seam to open it
7. Insert the motherboard slot
8. Fix the hard drive screws (included with the motherboard)
9. Installation is complete