keyes brick Water Level Sensor(Pad hole) with Pin Header Module Board Analog Signal
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
615101297
Description:
This is a commonly used water level sensor. Its principle is through the exposed printed plane on the circuit board. The more water, the more wires will be connected. As the electrical contact area increases, the output voltage will gradually rise.
Specification:
Operating voltage: 3.3-5V (DC) Interface: Pin header Diameter: 3mm Signal: Analog signal Size: 65*22mm Line length: 200mm Weight: 4.2g
Package included:
1 x Water Level Sensor (wiring, the other items are not includes)
This is a commonly used water level sensor. Its principle is through the exposed printed plane on the circuit board. The more water, the more wires will be connected. As the electrical contact area increases, the output voltage will gradually rise.
Specification:
Operating voltage: 3.3-5V (DC) Interface: Pin header Diameter: 3mm Signal: Analog signal Size: 65*22mm Line length: 200mm Weight: 4.2g
Package included:
1 x Water Level Sensor (wiring, the other items are not includes)
