LDR on PCB (light dependent resistor)
New
Shipping
Standard courier shipping from R60
R60 Standard shipping applies to orders under R100, in most areas in South Africa. R30 Standard shipping applies to orders over R100. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 3 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Product information
Condition:
New
Location:
South Africa
Product code:
SEN-017
Bob Shop ID:
596557610
This light-dependent resistor sensor measures the presence of light.
Features:
1. Uses a sensitive photosensitive resistance sensor. Light-dependent resistors are widely used to detect light.
2. Comparator output, clean signal, good waveform, strong driving ability, more than 15mA.
3. Adjustable potentiometer, which can adjust the brightness of the light detection
4. The working voltage is 3.3V-5V
5. Output form: DO digital switching output (0 and 1)
6. With fixed bolt hole, easy to install
7. Small size: 3.2cm x 1.4cm PCB
8. Use a wide voltage LM393 comparator
LDR on PCB (light dependant resistor) Instructions:
1. The light-dependent resistor module is most sensitive to ambient light. It is usually used to detect the brightness of the light in the surrounding environment and trigger the microcontroller or relay module;
2, The ambient light brightness module can not reach the set threshold, the DO end outputs a high level. When the ambient light brightness exceeds the set threshold, the DO end output is low level;
3, DO output can be directly connected with the microcontroller, through the microcontroller to detect high and low levels, to detect the environment light brightness changes;
4, DO output can directly drive the relay module, which can form a light control switch.
Wiring Instructions:
1 VCC connection power supply positive 3.3-5V
2 GND power supply negative pole
3 DO TTL switch signal output
Usage:
Light intensity detection, light intensity sensor, intelligent car light detection module
Package Included:
1 x light dependent resistor Sensor Module