Li-Po Battery 1s Plug 1 to 4 Charging Cable DIY Walkera Mini Super CP
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
615160356
Description:
Walkera Mini CP,V120D02S and other small electric helicopters' 1S charger can only charge fot two battaries in the same time.After using these accessories in the package and weld them in the old 1S charger,then the charger which is upgraded can charge four batteries in the same time.
Before welding components, please look at the following pictures.
Two components weld at site which they mark in rectangle.
Electric resistance can use the 1.2K units which mark in rounded rectangle.
The electric resistance marked in red rhombus should change into 1.2K electric resistance.
The capacitance marked in ellipse should all weld in 100nF units.
The led should keep the same high as before.
Blue arrow should keep the oringnal led in the same direction.
Do not make a mistake of Plus-n-Minus.Red is corresponding to positive electrode.Black is corresponding to negative electrode.
The electric wires position is depend on your own.
Package include:
1 x 1s Upgraded Charging Package
Walkera Mini CP,V120D02S and other small electric helicopters' 1S charger can only charge fot two battaries in the same time.After using these accessories in the package and weld them in the old 1S charger,then the charger which is upgraded can charge four batteries in the same time.
Before welding components, please look at the following pictures.
Two components weld at site which they mark in rectangle.
Electric resistance can use the 1.2K units which mark in rounded rectangle.
The electric resistance marked in red rhombus should change into 1.2K electric resistance.
The capacitance marked in ellipse should all weld in 100nF units.
The led should keep the same high as before.
Blue arrow should keep the oringnal led in the same direction.
Do not make a mistake of Plus-n-Minus.Red is corresponding to positive electrode.Black is corresponding to negative electrode.
The electric wires position is depend on your own.
Package include:
1 x 1s Upgraded Charging Package