M100 ELM327 Bluetooth 4.0 OBD2 Fault Diagnostic Scanner
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
CRP1546
Bob Shop ID
614646046
M100 ELM327 Bluetooth 4.0 OBD2 Fault Diagnostic Scanner
Function
1. Quick Scan: Quickly obtain vehicle information, smoke test, MIL status, and DTC information.
2. Read DTCs: You can read stored DTCs, pending DTCs, and permanent DTCs, and give maintenance instructions.
3. Clear the fault code: After selecting to clear the fault code, the yellow engine fault light on the instrument panel goes out.
4. Data flow: Read the real-time data flow information of the engine, and display the current data flow through numbers, dashboards, graphs, etc.
5. Freeze frame: Read the relevant freeze data when the vehicle has a fault code.
6. Smoke test: Read the status of detectors such as misfire, fuel system, NMHC catalyst, etc.
7. Oxygen sensing: Read the oxygen sensor monitoring test results.
8. Mode 6: Request the on-board surveillance test results for a specific surveillance system.
9. MIL status: read the data before and after the engine failure.
10. Vehicle information: Read vehicle information such as VIN, calibration ID, and simplified verification code.
11. View reports: View reports such as quick scan, fault code analysis, etc.
Supported Protocol
1. SAE J1850 PWM (41.6Kbaud)
2. SAE J1850 VPW (10.4Kbaud)
3. ISO9141-2(5 baud init, 10.4Kbaud)
4. ISO14230-4 KWP (5 baud init, 10.4 Kbaud)
5. ISO14230-4 KWP (fast init, 10.4 Kbaud)
6. ISO15765-4 CAN (11bit ID, 500 Kbaud)
7. ISO15765-4 CAN (29bit ID, 500 Kbaud)
8. ISO15765-4 CAN (11bit ID, 250 Kbaud)
9. ISO15765-4 CAN (29bit ID, 250 Kbaud)
Specification
1. Communication method: Bluetooth 4.0
2. Working voltage: 12V
3. Working current: 26mA
4. Working temperature: -40~80 degrees Celsius
5. Working humidity: less than 60%
6. Product size: 47x46x24mm