M18x1.5 O2 Oxygen Sensor Angled Extender Spacer 90 Degrees

M18x1.5 O2 Oxygen Sensor Angled Extender Spacer 90 Degrees

20 available / new
R347.00
Shipping
R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate
The seller has indicated that they will usually have this item ready to ship within 12 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:
 
Standard Delivery
Main centres:  1-3 business days
Regional areas: 3-4 business days
Remote areas: 3-5 business days
Seller
Buyer protection
Returns
Replacement Guarantee: 7 Days: We stand by this guarantee
Get it now, pay later

Product details

Condition
New
Location
International
Bob Shop ID
640890862
In vehicles with EURO 3 and higher vehicle emissions standards the second lambda oxygen sensor emulator is located after the catalytic converter. It plays a diagnostics role. If it detects any irregularities on the basis of the data from the engine control unit it displays an error on the dashboard and the engine can switch into emergency mode (depending on the make of car). It is often manifested by big power drop.These problems arise in the event of removal of the catalyst, its low efficiency, or its replacement with jet pump. In such situations, it becomes necessary to mount THE SECOND LAMBDA OXYGEN SENSOR EXTENDER.Color: SilverThe catalyst can effectively reduce the power output of 2 to 3%, and the maximum power speed of up to 5%. Its removal and the use of emulator is the easiest way to low-cost raise of power; The emulator can also help in case of problems with the LPG installation, which due to the detection of very rich mixture will display the CHECK ENGINE on the dashboard.Features:Polished front surfaces enabling perfect tightening.Washer in the set, ability to adjust the angle of screwing in the extender.Threads are made with dedicated tool, perfect accuracy and repeatability.Exhaust gas inlet hole 2 mm; In extreme situations narrowing of the inlet hole prevents motor failure (driving at high speed).Perfect for tight awkward spaces, where there is no room for the straight extendersInstallation:Unscrew the lambda oxygen sensor, screw in the emulator in its place and then screw in the oxygen sensor.Extenders are fromSpecifications:Material: IronInternal and External Thread: M18x1.5Height: 40mmPackage Size: 5 * 4 * 3cm / 2 * 1.6 * 1.2inWeight: 130g / 4.6ozPackage Contents:1*Oxygen Sensor ExtenderOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
Add to cart

Recently viewed

See more
40648 Money Tree
R499.00
Original LEXMARK 520Z MS710 / MS810 / MX710 / MX810 Return Program Imaging Unit
R1,615.00
LC-SC Single-Core Single Mode Fiber Optic Jumper,Length: 3m
R235.92
Board Game iKnow Board Game Trivia Board Game
R400.00

Similar products

3x Angle 90 Lambda O2 Oxygen Sensor Extender Spacer for Decat
R563.00
Oxygen Sensor Spacer Joints Catalytic Converter 50mm M18*1.5
R340.00
234-4527 O2 Oxygen Sensor for Chevrolet Cruze Sonic 1.8l 2011-2016
R576.00
Universal M18 X 1.5 Oxygen O2 Sensor Spacer 90 Degree Bung Pipe Kit
R449.00