M5Stack PuppyC Programmable 4-Leged Robot Base Compatible with M5StickC STM32F030F4 Microcontrolle
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
615105467
Description: ? 1. PuppyC s a programmable four-legged robot base compatible with M5StickC. It contains the STM32F030F4 microcontroller,Four SG90 micro servos, a battery holder and an independent switch. 2. PuppyC base needs to be used in conjunction with the M5StickC controller.After the StickC is programmed, it communicates with PuppyC through the I2C protocol to control the steering motion. 3. It walks slowly and is easy to control.Due to the small contact area, the movement is slow and the frictional force is as large as possible even on a soft surface. ? Product Features: ? Programmable robot Servo controller Four-legs walking Dimensions LxWxH: 52mm * 60mm * 35mm Weight: 58g Servo angle range : 0-180?ﾣ ? Applications: ? Robotic pet Remote Control Robot Smart and cognitive toys ? Package Included: ? 1x PuppyC base 1x 16340 Battery 4x SG90 Servo ? ? 1.EasyLoader is a simple and fast program burner. Every product page in EasyLoader provides a product-related case program. This can be burned to the M5 device through simple steps, and a series of function verifications can be performed. ? 2.After downloading the software, double-click to run the application, connect the M5 device to the computer through the data cable, select the port parameters, click Burn to burn the program (For M5StickC, set the baud rate to 115200 or 750000) ? Code ? 1. for IDE To get complete code, please click ?
