This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1672
Similar products
M5Stack SERVO Hat Motor Module with ES9251II Digital Servo for M5StickC ESP32 IoT Development Boar
New
R654.00
Closed
11 May 24 00:03
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
612366957
Description:
SERVO HAT?as the name suggests, is a servo motor module with the new and upgraded ES9251II digital servo,This comes with 145?ﾣ±10?ﾣ range of motion and can be controlled by PWM signals. The signal pin of the hat is connected to G26 on M5StickC.
Product Features:
- Servo Type: a?? Digital
- Spinning speed:a?? 0.09sec/60?ﾣ
- Gear material:a?? Plastic
- Weight: a?? 2.5g
- Torque: a?? 0.25Kgf.cm(at 4.8v)
- Voltage: a?? 5.0V±0.2V
Weight and Size:
- Size: 24mm * 29mm * 23mm
- weight: 9g
Included:
- 1x Servo HAT
Applications:
- Analog indication
- Angle and direction control
- Door lock controller
Schematic:
1.EasyLoader is a simple and fast program burner. Every product page in EasyLoader provides a product-related case program. This can be burned to the M5 device through simple steps, and a series of function verifications can be performed.
2.After downloading the software, double-click to run the application, connect the M5 device to the computer through the data cable, select the port parameters, click?Burn?to burn the program (For M5StickC, set the baud rate to 115200 or 750000)
Example:
- for?
