Name: Marbelite 20kg Weber White
SKU: 6803006
Price: 173.00 ZAR
Availability: SoldOut
Rating: 5 (1 reviews)

Marbelite 20kg Weber White

New

201 were available

R173.00

Shipping

R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller has indicated that they will usually have this item ready to ship within 7 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

Swemgat127

100.00 % Positive ratings

Buyer protection

How you're covered

Get it now, pay later

Condition

New

Location

South Africa

Customer ratings:

1 ratings

Product code

6803006

Bob Shop ID

417332360

How to Re-Plaster a pool using marbelite

Surface Preparation

1. Remove any loose plaster completely and chip at least 80% of the surface using steel hammers.

2. Acid wash the surface using a solution of 1 part hydrochloric acid and 3 parts water and wire-brush vigorously

3. Flush clean with plenty of water

4. Prepare a slurry consisting of Marbelite in a solution of 1 volume Weber Slurrybond and 4 volumes water.

5. Apply to the surface using a block-brush Allow the slurry to harden for 12 hours (but no longer than 24 hours)

------------------------------------------------------

1. Remove any dust or loose materials by brushing the surface thoroughly Flush clean with plenty of water.

2. Remove any excess water.

3. The surface must be damp, but not glistening with water, before plastering.

How to Plaster a New Pool using Marbelite

Mixing

1. Mix Marbelite using 3.2 litres of water per 20kg bag. Do not add extra water.

2. The mix should be stiff, with little slump

Application

1. Apply the first layer by forcing the material tightly against the surface using a rounded steel trowel

2. Follow immediately with a second layer to an application not exceeding 8mm.

3. Plaster the walls first and then the floor All plastering must be completed in one day to avoid unsightly joint marks.

4. When the surface is green (set but not fully hardened) it should be given a final trowelling to polish the surface and remove trowel marks.

5. Wet the surface slightly to avoid black burn marks.

6. The surface can be polished to a verysmooth finish

Finishing

1. Clean all mosaics, tiles and surrounds Leave the finished pool overnight to air cure

2. Start filling the pool the next day from the deep end Attach a deflector to the end of the hosepipe to prevent surface damage.

3. Damp down exposed Marbelite every hour to prevent it drying prematurely Fill the pool in one operation to prevent a water-ring from forming.

Features & benefits

Carefully graded aggregates to produce a fine finish

Integrally coloured

Quality assured raw materials

Exceptional and consistent quality

Backed by superior technical support

Available in a range of colours

Report a problem

Similar products

Marbelite 20kg Weber White

Product details

Features & benefits

Recently viewed

Customer ratings: 1 ratings

Similar products

Marbelite 20kg Weber White

Product details

5.0 out of 5

Features & benefits

Recently viewed

Customer ratings: 1 ratings