MAX7219 Point Battage Module LH Control Single-Chip Module 4 In 1 Display With 5P Cable, Specific...
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
TBD0604259003
Bob Shop ID
601995806
1. A single module can drive an 8x8 common negative dot matrix
2. Module operating voltage: 5V
3. With 64 fixed screw holes, hole diameter 3mm
4. With input/output interfaces, support multiple modules cascade.
5. 3 IO ports can drive 1 dot matrix, no flicker when displaying.
6. Size: 12.8 x 3.2 x 1.3cm, cable length about 20cm
7. Weight: about 45.2g
Wiring instructions:
1. Left side is input port, right side is output port.
2. When controlling a single module, connect the input port to the CPU.
3. When multiple modules are cascaded, the input of the first module is connected to the CPU, the output is connected to the input of the second module, the output of the second module is connected to the input of the third module, and so on.
4. Take 51 microcontroller as an example:
- VCC 5V
- GND GND
- DIN P2.2
- CS P2.1
- CLK P2.0