| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Repair the peeling or partial damage of the solder mask on computer and mobile phone PCB circuit boards.
Insulates printed circuit board against shorting and arcing.
Color: Green
Syringe Length: Approx. 10 cm
Material: Paint
Capacity: 10 ml
* Note that if you are using a 395nm UV light to cure this product , you must apply a VERY THIN layer of mask , and then cure . A 395nm UV light will not cure a thicker layer properly - A 365nm UV light is the prefered recommended UV Lamp
Usage:
Apply a VERY thin layer of paint - A small amount spreads far- Do not over apply
To Cure , exposure to ultraviolet light (or sunlight) for a few minutes.
Tip - A warm PCB ( 120 C ) helps with the curing . Best results are achieved with a combination of Simultaneous hot air ( 300C for a few seconds ) and UV light
Wash off excess paint with a Q-tip and alcohol
* Note that if you are using a 395nm UV light to cure , you must apply a VERY THIN layer of mask , and then cure . A 395nm UV light will not cure a thicker layer properly
.jpg)
