MECHANIC Solder Mask 10cc Green UV PCB BGA Paint

Repair the peeling or partial damage of the solder mask on computer and mobile phone PCB circuit boards.

Insulates printed circuit board against shorting and arcing.

Color: Green

Syringe Length: Approx. 10 cm

Material: Paint

Capacity: 10 ml

 * Note that if you are using a 395nm UV light to cure this product , you must apply a VERY THIN layer of mask , and then cure . A 395nm UV light will not cure a thicker layer properly  - A 365nm UV light is the prefered recommended UV Lamp 

Usage:

Apply a VERY thin layer of paint - A small amount spreads far- Do not over apply  

To Cure , exposure to ultraviolet light (or sunlight) for a few minutes.

Tip - A warm PCB ( 120 C ) helps with the curing . Best results are achieved with a combination of Simultaneous hot air ( 300C for a few seconds ) and UV light 

Wash off excess paint with a Q-tip and alcohol 

 * Note that if you are using a 395nm UV light to cure , you must apply a VERY THIN layer of mask , and then cure . A 395nm UV light will not cure a thicker layer properly