This item has closed 5 buyers bought 5 items
View other items offered by Console Xtreme5407

Similar products

UniFormation Cure3 - UV Resin Curing Station
New
R11,347.35
Amtech Soldering Flux Paste Tube - BGA Flux NC-559-ASM-UV (TPF)
New
R99.00
Mechanic BGA Soldering paste 50G
New
R267.60
32% OFF
Bench Vise Table Clamp Soldering Station With 5Pc Flexible Arms Soldering Iron Holder Pcb Welding Re
New
R613.78 R902.78
MECHANIC Solder Mask 10cc Green UV PCB Paint With UV Light
Sold

MECHANIC Solder Mask 10cc Green UV PCB Paint With UV Light

New 6 were available
R352.92
Shipping
R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate
The seller has indicated that they will usually have this item ready to ship within 4 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:
 
Standard Delivery
Main centres:  1-3 business days
Regional areas: 3-4 business days
Remote areas: 3-5 business days
Buyer protection
Get it now, pay later

Product details

Condition
New
Location
South Africa
Customer ratings:
Product code
4915
Bob Shop ID
616073336

 

Description:

100% brand new

High quality 10

Ml's UV green paint.

Keep printed circuit boards free from short circuits and arcs.

This paint is used to protect PCB traces from corrosion and moisture. It can also be used for PCB repair after soldering and rework.

 

Specification:

Welding oil: green/blue/yellow/red/black

Syringe length: approx. 10 cm

Material: Coating

Capacity: 10ml

Lights: 9 LEDs

Quality: brand new

Voltage: about 4.5V

Power Supply: 3 AAA batteries (not included)

Application: LOCA UV Adhesives for Mobile Phone Repair

Weight: 40g

Size: 87mm * 26mm

Quality: brand new

 395nm UV light

Usage:

Apply a VERY thin layer of paint - A small amount spreads far- Do not over apply  

To Cure , exposure to ultraviolet light (or sunlight) for a few minutes.

Tip - A warm PCB ( 120 C ) helps with the curing . Best results are achieved with a combination of Simultaneous hot air ( 300C for a few seconds ) and UV light 

Wash off excess paint with a Q-tip and alcohol 

 * Note that if you are using a 395nm UV light to cure , you must apply a VERY THIN layer of mask , and then cure . A 395nm UV light will not cure a thicker layer properly  

 

Recently viewed

See more
The Last Time DVD (Michael Keaton, Brendan Fraser)
Secondhand
R25.00
The First Aviators
Secondhand
R65.00
Elize Parker omnibus - Elize Parker
New
R240.00
PS3 Castlevania Lords Of Shadow 2
Secondhand
R862.00 No bids

Customer ratings: 1 ratings

Quick service delivery👌🏽
11 Oct 2024