This item has closed 1 buyer bought 1 item
View other items offered by Northern Bolt & Tool587

Similar products

Excellway CH2 Quick Wire Connector Terminal Block Spring Connector
R278.00
R134a Compressor Oil ND-OIL N8
R359.00
0.3mm Mini Spray Guun Action Air Brush Handheld Pistol Airbrush Pen Compressor... (COLOR.: ROSEGOLD)
R1,007.00
16% OFF
Microwave Oven Micro Switch
R79.69 R95.00
Micro-Tec External Coil Spring Compressor Set
Sold

Micro-Tec External Coil Spring Compressor Set

20 were available / new
R490.00
Shipping
R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate
The seller allows collection for this item. Buyers will receive the collection address and time once the order is ready.
The seller has indicated that they will usually have this item ready to ship within 3 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:
 
Standard Delivery
Main centres:  1-3 business days
Regional areas: 3-4 business days
Remote areas: 3-5 business days
Buyer protection
Get it now, pay later

Product details

Condition
New
Location
South Africa
Customer ratings:
Product code
M007012
Bob Shop ID
542113420

Micro-Tec External Coil Spring Compressor Set

External Coil Spring Compressor Set
Removes And Installs Coil Springs Where Removal Through The Center Of The Spring Is Not Possible
Services Both Straight &Amp; Curved Coil Springs
Includes U-Bolts &Amp; Wing Nuts
Maximum Diameter Spring That The Hooks Will Accommodate Is 0.75?.
Diameter Of The Rod: 5/8?
Instructions For Straight Coil Springs:
1. Install 3 Leg Assemblies Evenly Around The Spring. Turn Nuts Finger-Tight To Hold In Position.
2. Install One U-Bolt Near The Center Of Each Leg With Open End Pointing Away From The Spring. Place The Bar And Wing Nuts On The U-Bolt, Then Finger-Tighten The Wing Nuts
3. Tighten Each Leg Nut A Little At A Time To Compress Spring Gradually. Do Not Over-Compress.
4. To Release The Compressor, Loosen Each Leg Nut A Little At A Time.
Instructions For Curved Coil Springs:
1. With The Car Raised And Safely Supported, Place A Jack Under The Lower Control Arm. Raising The Jack Will Compress The Spring.
2. Install As Many Leg Assemblies And Safety U-Bolts As Possible (See #1 &Amp; #2 Above), Then Finger-Tighten The Leg Nuts.
3. Disconnect The Lower Control Arm Bolts, Then Slowly Lower The Jack Until The Spring Can Be Removed. The Curved Contour Will Remain.
4. To Install A New Coil Spring, Use One Or More Legs And U-Bolts To Produce The Necessary Curve.

Sku: M007012

Customer ratings: 1 ratings

Superfast delivery and great quality item. Will do business again.
16 Feb 2022