Microphone Noise Decibel Sound Sensor Measurement Module 3p / 4p Interface Geekcreit for Arduino - p
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
615105877
Features: ? - This module can be connected to the analog I / O port, - when speaking to the microphone, the analog value will be changed. - A recorder can be made by reading and saving the analog value. ? Specifications:
?
? ?
? ? DEMO:
Connect S port of electronic brick of microphone to A0 port of for , and we will use the following program to read the analog value. When the value exceeds the threshold, the LED indicator will flash. ? 1const int ledPin = 13; // the number of the LED pin
2const int thresholdvalue=400; //The threshold to turn the led on
3void setup() {
4pinMode(ledPin, OUTPUT);
5}
6void loop() {
7 int sensorValue = analogRead(A0); //use A0 to read the electrical signal
8 if(sensorValue>thresholdvalue)
9digitalWrite(ledPin,HIGH); //if the value read from A0 is larger than 400,then light the LED
10 delay(200);
11 digitalWrite(ledPin,LOW);
12}?
Package Included:
1 x?Microphone Noise Decibel Sound Sensor Measurement Module
?
| Brick Type | Sensor Brick |
| Brick Interface | 3PIN |
| Brick Power Supply | 5V |
| Board Size | 33 ?? 14 ?? 1.6mm |
| Parameter | Min. | Typical | Max. | Unit |
| Working voltage | 4.5 | 5 | 5.5 | VDC |
| Digital output voltageVCC=5V | 0 | - | 5 | V |
| Working current5V | - | 260 | - | uA |
| Frequency range | 100 | - | 10000 | Hz |
| Sensitivity | - | -50 | - | dB |
Connect S port of electronic brick of microphone to A0 port of for , and we will use the following program to read the analog value. When the value exceeds the threshold, the LED indicator will flash. ? 1const int ledPin = 13; // the number of the LED pin
2const int thresholdvalue=400; //The threshold to turn the led on
3void setup() {
4pinMode(ledPin, OUTPUT);
5}
6void loop() {
7 int sensorValue = analogRead(A0); //use A0 to read the electrical signal
8 if(sensorValue>thresholdvalue)
9digitalWrite(ledPin,HIGH); //if the value read from A0 is larger than 400,then light the LED
10 delay(200);
11 digitalWrite(ledPin,LOW);
12}?
Package Included:
1 x?Microphone Noise Decibel Sound Sensor Measurement Module