Mini Dual Gigabit Ethernet Base Board Designed for Raspberry Pi Compute Module 4
New
Indicative market price: R838.21
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Free collection from
Henley on Klip, Meyerton
The seller allows collection for this item and will be in contact with the full collection address once the order is ready.
Ready for collection by Thursday, 9 May.
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 2 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Product information
Condition:
New
Location:
South Africa
Product code:
3256
Bob Shop ID:
613701495
Dual Gigabit Ethernet Base Board For CM4
Mini, Practical And Neat
Suitable For Evaluating The Raspberry Pi CM4 Or Being Integrated Into End
Dual Gigabit Ethernet Base Board
Specifications
- CM4 SOCKET: suitable for all variants of Compute Module 4
- NETWORKING" Dual Gigabit Ethernet RJ45 connectorUSBUSB 2.0 Port
- PIN HEADER: Raspberry Pi 40PIN GPIO header
- STORAGE: TF card socket for Compute Module 4 Lite (without eMMC) variants
- FAN HEADER: 4-wire SH1.0 port, allows speed adjustment and measurement, 5V
- POWER INPUT: 5V, Type-C interfaceDIMENSIONS55.0 68.0mm
Connecting With Compute Module 4
Standard CM4 Socket And 40PIN GPIO Header
Suitable For Compute Module 4 Lite/EMMC Series Module
Rich Interfaces
What's On Board
- 40PIN GPIO header
for connecting sorts of HAT - CM4 Socket
suitable for all variants of Compute Module 4 - RJ45 Dual Gigabit Ethernet Port
Dual RJ45 Gigabit Ethernet ports, 10/100/1000M compatible
ETHERNET 0: CM4 original network port
ETHERNET 1: PCIe extended network port - USB 2.0 Type A port
for connecting sorts of USB devices - FAN header
for connecting cooling fan, allows speed adjustment and measurement - Reset button
- Boot switch
ON: CM4 would be booted from USB-C interface
OFF: CM4 would be booted from eMMC or TF car
- Type-C port
5V/2.5A power supply, or used for eMMC programming - TF card slot
for connecting a TF card with pre-burnt image (Lite variant ONLY) - RTL8111H
Gigabit NIC chip - Indicator
PWR: indicating the power supply status of Raspberry Pi
SYS: indicating the working status of Raspberry Pi - SYSTEM switch
EEPROM_WP: Prevent EEPROM from being overwritten
WiFi_DIS: WiFi disabled, only for CM4 version with wireless
BT_DIS: Bluetooth disabled, only for CM4 version with wireless
What's in the box?
1 x Mini Dual Gigabit Ethernet Base Board Designed for Raspberry Pi Compute Module 4
Resources
WIKI: www.waveshare.com/wiki/CM4-DUAL-ETH-MINI