[Operating Instructions]: [1] Power on: the red light, blue light, and green light flash once each and then go out. [2] Standby: The red light is breathing and flashing, and when the temperature reaches the highest level, it automatically changes to the blue light in mid-range. [3] Working status: The indicator light is always on (high range: the red light is always on, mid-range: the blue light is always on, low range: the green light is always on)[Operating Instructions]: [4] Press and hold the power button for 3 seconds: enter standby mode or shut down [5] Click the switch key: switch gears[How to use the switch]: Press and hold for 3 seconds to turn on the phone, the red breathing light will turn on. After reaching a certain temperature, it will automatically turn to blue.Press it once to change to the blue light. The temperature is medium temperature. Press twice and it will turn green.The temperature is The lowest,press three times for the red three-level high temperature, press and hold for 3 seconds to shut down.22MM handlebar inner diameter, suitable for most motorcycles.One-piece molding prevents rain and dust from entering internal corrosion parts, making the service life longer and . Built-in intelligent temperature control chip, three levels of adjustable temperature, intelligent temperature control is . Double throttle cable buckle, installation range. Sealable and open-mouth design does not affect the installation of handle plugs on the outside of the handle, so that lights and other decorative accessories can be installed.The product has added a standby mode. After switching to the standby state, the electric heated handle will automatically adjust the temperature to about 50 degrees.Handle temperature:low temperature 40C, medium temperature 50C, high temperature 60C (the above data are obtained from experimen, the laboratory room temperature is 15-20C, the specific values due to objective factors such as voltage and environment) There may be slight fluctuation, for reference only)Product wiring :1. Connect to the circuit of the motorcycle electric door lock (behind the key), the red wire to the positive output wire of the electric door lock, and the black wire to any negative pole or ground on the car [This is suitable for those who do not want to use it, Riders who are in standby mode but tend to forget to turn off the switch]2. Connect to the positive and negative poles of the battery.The red wire is connected to the positive battery pole [+], and the black wire is connected to the negative pole [-] of the battery.Warm reminder:When wiring, connect red to the positive pole and black to the negative pole.If the connection is reversed, the switch will burn, but the handle will heat up,so when wiring, please confirm the positive and negative terminals before wiring to prevent burning.Suitable pipe diameter:22mmInput voltage:DC12VProduct power:red light 35W,blue light 25W,green light 17WHandle type:Sealing or opening electric heating handleSwitch type:Multi-level adjustable temperature control switchApplicable models:12V motorcycles with handlebar diameter of 22mmDue to different batches,there may be differences in product appearance,color,and printed text,which will not affect the use.Colour:BlackMaterial:Nitrile materialSize:Left hand handle:137x30MM; handle:125x30mmPackage Contents:1set x Motorcycle Hand Heated GripsOnly the above package content, other products are not included.Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +\/- 1-3cm.
