Mountain Road Bicycle Headset Installation Tool Steel Flower Core Installation Sleeve Tool(Sun Fl...
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
TBD0583450701A
Bob Shop ID
602526340
1. Material: aluminum alloy, steel
2. Application: steel/aluminum alloy/titanium alloy front fork with an outer diameter of 26.8mm at the upper end (full carbon fiber front fork cannot be used)
3. Packing list: aluminum alloy sleeve x1, steel flower core rod x1, sun flower x1, holding screw x2
4. Features: simple operation, automatic positioning of the left and right of the flower core and depth, the sleeve edge is round and does not hurt your hands, 304 stainless steel holding screws, not easy to rust
5. Weight: about 245g/set
Installation notes:
1. After the front fork is cut off, the vertical tube is squeezed by force and the edge is turned outward. Before driving into the sun flower, use a file to polish the edge to prevent the sleeve from jamming.
2. Screw on the steel sunflower and screw it to the end
3. Put on the sleeve and prepare to drive in
4. Knock the ejector rod with a rubber mallet until it is flush with the sleeve
5. Remove the sleeve and ejector rod, the installation is complete