PVC MULTIFUNCTIONAL ADJUSTABLE UMBRELLA ANCHOR
SIZES ADJUSTABLE FROM 17mm - 33mm
PVC MULTIFUCTIONAL UMBRELLA ANCHOR
PRODUCT DESCRIPTION:
Plastic umbrella anchor used for anchoring umbrella's, tents, gazebo's, small boats, torches, fishing rods, securing kites and small pets, volleyball poles, creating wahsing lines ect.
2 Plastic handles for easy twisting action.
Several water drainage holes present
Utilized in:
Grass, Sand, and Soil
The diameter of the product is:
Inner: 4cm,
Outer: 6cm
Total length: 42cm from point to point
And the length inside: 24cm
ANCHOR YOUR VOLLEY BALL NET, ANCHOR YOUR TENT, SECURE SMALL PET
ANCHOR YOUR FLAG, ANCHOR YOUR FISHING ROD ANCHOR AND SECURE YOUR GAZEBO
SECURE YOUR KITE, ANCHOR YOUR TORCH ANCHOR POLES AND CREATE WASHING LINE FOR WET CLOTHES OR TOWLS
ANCHOR YOUR SMALL BOAT, KAYAK OR CANOE
DIRECTIONS AND UTILIZATION IN GENERAL
- Place the anchor on the desired spot where anchoring is required.
- Open up and extent the two handles.
- Apply equal pressure on both handles making sure the anchor is kept in a vertical
position to ensure the anchor doesn’t go in at skewed angle.
- Twist anchor evenly till thread has reached required depth.
- If anchor is secure, adjust fitting to required size needed
UTILIZATION IN SAND:
For best results the following procedure is advised:
- First remove all the soft loose sand on the top (approximately 15 – 20cm of sand)
- Twist anchor evenly into the sand applying pressure equally on the handles.
- Anchor should be turned into the sand until the total thread surface is covered
- Throw and pitch the loose sand around the anchor and step on the sand to secure
and steady it.
PLEASE READ
The umbrella anchor is mainly designed for the anchoring of umbrellas.
Examples and illustrations given for utilizing the product for purposes other than anchoring umbrellas should only be exercised after utmost discretion has been taken.
Anchor should not be utilized and put under unnecessary and extreme stress which would relate and cause the product to break and fail.
