Nibbler attachment for drills for cutting sheet metals
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 3 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
South Africa
Product code
TC10008
Bob Shop ID
616068826
TorkCraft - Sheet Metal Cutter
Attachment for Drills
Attachment for Drills
Carded Pack: Qty 1
Application:
Sheet metal cutters allows for cutting straight or irregular shapes into sheet metal stainless steel and other soft materials with a standard electric drilling machine, cordless drill or pneumatic drill.
- Fits any electric drill or cordless drill.
- Different cutting shapes achievable - straight / curve / 360
- Recommended cutting speed 3000RPM
- For sheet metal cutting: Sheet Metal 1.8mm MAX. / Stainless steel 1.2mm MAX,
- For other material cutting: Aluminium 2.0mm MAX. / Plastic or Plywood 2.0mm MAX.
Working Safe:
- Ensure the work piece is clamped and secured before cutting.
- Fit any electric drill or cordless drill to the 1/4' hex drive shaft.
- Do not cut a thicker sheet of material than stipulated.
- Never start cutting before the tool is running at the set speed.
- Keep a vertical angle between the cutting bit and the sheet
- Finish cutting through material before stopping your drilling machine,
- Make sure the plastic handle is screwed over the cutter (not in use) to allow for a safe grip
WARNING: Using any tool can be dangerous. Always select the right tool for the job. The tool can get hot after use, cutting edges can be very sharp.