Off-road Vehicle / Automatic 40A Manual Circuit Breaker Overcurrent Protector
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
CRP1649
Bob Shop ID
593689458
1. Rated current: 40A
2. Rated voltage: 48VDC Maximum
3. Disconnecting capacity: 3000A 48 Vdc
4. Ambient temperature: -32~82 degrees Celsius (-25~180 degrees Fahrenheit)
5. Storage temperature: -34~149 degrees Celsius (-30~300 degrees Fahrenheit)
6. Stud size: 1/4 inch -28
7. Application: Mainly used for electric current overload protection of ships and motor homes.
8. Function: To prevent excessive current and protect electrical appliances.
9. Operation method: It is easy to operate. When the circuit is disconnected, you don not need to remove it. You can disconnect it by pressing once. To use it normally, just push the red button on the disconnect back.
2. Rated voltage: 48VDC Maximum
3. Disconnecting capacity: 3000A 48 Vdc
4. Ambient temperature: -32~82 degrees Celsius (-25~180 degrees Fahrenheit)
5. Storage temperature: -34~149 degrees Celsius (-30~300 degrees Fahrenheit)
6. Stud size: 1/4 inch -28
7. Application: Mainly used for electric current overload protection of ships and motor homes.
8. Function: To prevent excessive current and protect electrical appliances.
9. Operation method: It is easy to operate. When the circuit is disconnected, you don not need to remove it. You can disconnect it by pressing once. To use it normally, just push the red button on the disconnect back.