ORIGINAL LCD Screen and Digitizer Full Assembly for SONY XA2 ULTRA

Description:

1. Brand New

2. Good quality LCD screen Assembly replacement part.

3. It is used to repair faulty screen: display problems, dead pixels, cracked LCD screens.

4. Assembly is tested before shipping and are 100% working

Instructions:

This is a Replacement LCD for your Phone, Please be careful while installing the LCD�..

1; Do not Peel Off the front and back Protection Sticker.

2; clip the LCD Connector flexi properly to your phone, Switch the phone on and Wait for the applications being optimized.

3; inspect the touch digitizer and Display thoroughly.

4; after inspection and making sure that the LCD has no manufacturing fault now you can peel off the back sticker, apply adhesive glue on the body of the phone and on the sides of the LCD.

5; Don't Push the LCD down on the frame while installing it, whereas it can damage the Display Glass from Inside.

6; Let the LCD adjusted into frame and Put some Rubber Bands on the Phone So the LCD remains Intact on the frame until the Glue is dried.

7; After an hour of installation remove the rubber bands , Clean the phone and Your phone is Ready to use.

Warranty terms:

Warranty terms are as follows.

The LCD Can only be returned to the Seller if the following conditions are met with.

1; The Unit is in the same Condition as it was shipped and received with the front and back Stickers-on.

2; Unit has no Scratch and was not installed on the Device.

3; Any manufacturing fault was noticed when inspecting the LCD which should be first reported to the saleSMan on the website and if approved for return be sent back.

What's in the Box?

1 x LCD FOR SONY XA2 ULTRA