Pcsensor 100-Key Touch Switch Module Custom Keyboard And Mouse Test Development Board, Style:DIY
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
TBD0203016401
Bob Shop ID
593628776
1. 100 keys, DIY keys can be set to various shortcut keys, combination keys, any single key
2. DIY: It can be DIYed into a standard USB keyboard and mouse with 100 custom keys, connected to the switch through two 10PIN cables, each key can be defined as keyboard function and mouse function through the supporting software, and can be set through the software The function of the switch and the function of the setting are stored in the device, and no other software is required during the use of the device
3. PCB: Optional 100 keys to help you test the function of the 100 keys set
4. Interface type: USB Type-c
5. Working voltage: 5V
6. Working current: 15mA
7. Keyboard function: a single shortcut key can be set; two combined shortcut keys can be set; three combined shortcut keys can be set;
8. Mouse function: You can set the left mouse button; you can set the middle mouse button; you can set the right mouse button; you can also set the movement of the X and Y axes and the up and down scrolling function of the wheel
9. Multi-system compatible, suitable for Mac, Dos, Windows All, Linux, Android
10. Material: PCBA board
11. Size: 4.2x4.2cm
Setting steps: When you want to change the function of the button, you can use the FootSwitch software to modify the function of the button:
1. Connect the device to the computer
2. Run the software FootSwitch
3. Select the button that needs to be changed
4. Click or enter the function you want to set
5. Click the Save to button