R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable. Check my rate
The seller allows collection for this item. Buyers will receive the collection address and time once the order is ready.
The seller has indicated that they will usually have this item
ready to ship within 3 business days.
Shipping time depends on your delivery address.
The most accurate delivery time will be calculated at checkout,
but in general, the following shipping times apply:
Four years after the original Pixracer was designed and proven, we recognized the need to bring the design to the forefront of open-source flight controllers. With the Pixracer Pro, we maintained everything that the UAV community loved about the original Pixracer and improved every deficiency that was known. The resulting model is destined to become the new go-to flight controller for developers and will provide a rock solid foundation for commercial and industrial systems.
Please visit our docs site for more information.
Main Processor: 32-bit STM32H743IIK6 Cortex M7 RISC core with FPU 460 MHz IO Processor: No RAM: 1024 KB RAM Flash: 2 MB FRAM Crypto / Hash Processor: No Accelerometers / Gyros / Mags: Yes Sensors: Invensense/TDK ICM-20602 (6DOF) Invensense/TDK ICM-20948 (9DOF) Sensors - Dampened: Bosch BMI085 (6DOF) (internally vibration dampened) Internal Magnetometer: AK09916 inside ICM-20948 Barometric Pressure Sensor: DPS310 Interfaces and Protocols: 6x UART (serial ports) [2x with HW flow control,1x FRSky Telemetry (D or X types), 2x General Purpose & 1x GPS+I2C 1x PPM sum input signal
8x PWM outputs (all DShot capable) 1x RSSI (PWM or voltage) input 1x I2C 1x SPI 2x CAN 1x JTAG (TC2030 Connector) 3x Ultra low noise LDO voltage regulator
Pin Headers: Yes - 8 Servo * pins are not soldered Conformal Coating: No Extended Testing and Burn In: No Custom Carrier Board Support: No LED:Yes (Tricolor)
Dimensions: Width: 36mm (1.42") / Length: 36mm (1.42") Weight: 9.09g (.31 oz) w/o pins Mounting Holes: 4mm holes at 30.5mm spacing, Silicone grommets for m3 screws Protector Case: No
