POOL LIGHT AQUAFLO ECONO LED RETROFIT BLUE

Installation is easy:

It is not necessary to drain a pool's water to replace pool lights (globes)
Remove the old light from the underwater housing by putting a flat screwdriver between the build-in housing and face-plate
Join the cable of the new light to the existing wire
12 Volt wires can come in contact with water, but it is not ideal to prevent rust
Press the light evenly by hand into the hole. As soon as it fits, use a rubber hammer and tap it on the edge in order to insert it completely.
Tip:

If your concrete or fibreglass moulded have an Quality pool light housing, the hole is about 2mm smaller than the LED replacement light. To make it fit; use a knife to trim the plastic or use sanding paper to reduce the thickness of the ribs in order to fit into the housing.
Warning:

Do not connect pool lights to 220V. Consult or hire a electrician to fit lights if you're in doubt or WHATSAPP 064 534 4691
Your pool DB Board and electrical circuit should have a 12 Volt transformer as power source to for underwater pool light(s).

PLEASE NOTE ALL POOL LIGHTS ARE TESTED PRIOR TO LEAVING THE WAREHOUSE ,A WHATSAPP VIDEO IS INCLUDED WITH YOUR PURCHASE AS PROOF OF TEST WITH TIME STAMP .DUE TO THE INSTALLATION NATURE OF PRODUCT LIGHTS CARRY ONLY FACTORY MALFUNCTION WARRANTY AND WILL BE TESTED AFTER PRODUCT IS RETURNED FOR A WARRANTY CLAIM BY FACTORY .WARRANTY CLAIM WILL ONLY BE ENTERTAINED IF A FACTORY FAULT IS DETECTED.ALL POOL LIGHTS CARRY A 6 MONTH FACTORY WARRANTY.INSTALLTION INVOICE WITH ELECTRICIANS DETAILS IS REQUIRED FOR A WARRANTY CLAIM TO BE PROCESSED.