Power Steering Rack with Rack End for Haval H6 & H6C (1.5T / 2.0T) - MAP-101014

Vehicle Fitment & Part Details

Power steering rack supplied with rack end for Haval H6 Gen 1 FWD 1.5T petrol (GW4G15B). Also fits Haval H6 Gen 2 FWD 1.5T and the Haval H6 / H6C Gen 1 (including TCi) 2.0T diesel (GW4D20). Confirm compatibility by matching the listed fitment details and verifying VIN/engine/chassis information where variants exist.

Key Details

SKU

MAP-101014

Component

Power Steering Rack

Configuration

Rack with rack end included

Primary Fitment

Haval H6 Gen 1 FWD 1.5T petrol (GW4G15B)

Vehicle Fitment

Fitment Notes

• Always match the engine code on your vehicle to the fitment table before ordering. Engine code can be confirmed on the engine block, emissions sticker, or via VIN lookup at a Haval dealer.
• Supplied with rack end included confirm whether your replacement scope also requires new inner/outer tie rod ends and boots before ordering.
• 4WD / AWD Haval H6 variants are not covered by this fitment this listing is for FWD 1.5T and the Gen 1 2.0T H6/H6C range only.
• If fitting to a Gen 2 H6, please verify the old rack's part number matches before ordering, as Gen 2 steering components can differ from Gen 1.

Installation / Use / Maintenance Tips

• Steering rack replacement must be done by a qualified workshop incorrect fitment or bleeding can cause steering failure.
• Always have a full 4-wheel alignment done immediately after rack replacement; steering geometry will be out of spec until aligned.
• Inspect the inner and outer tie rod ends, tie rod boots, and steering column universal joint for wear while the rack is removed; replace any worn components at the same time.
• Flush and refill the power steering system with the correct Haval-specification fluid; bleed the system fully to remove air and check for leaks under full-lock turns.
• Check steering wheel centring and self-centring behaviour after alignment; pulling or off-centre steering wheel indicates alignment or rack issues that must be corrected before road use.

Common Questions

Will this steering rack fit my Haval H6?
This part (MAP-101014) is listed for the fitments shown on this page. Confirm by matching the engine code (GW4G15B petrol or GW4D20 diesel) and verifying VIN/engine information before ordering.

Is a rack end included?
Yes this listing is a power steering rack supplied with rack end included. Inner and outer tie rod ends and boots are not included unless specifically stated.

Does this fit 4WD / AWD Haval H6 models?
No this rack is for FWD 1.5T and Gen 1 2.0T H6/H6C models only. 4WD variants use a different steering rack specification.

How do I confirm fitment if there are multiple variants?
Use VIN, engine code, and generation details and compare them to the fitment section above. If unsure, request fitment assistance before ordering.