Pre-wired Electronics for 2 x Humbucker with Master Volume and Master Tone with Coil Split (Solderle
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Free collection from
Capri, Cape Town
The seller allows collection for this item and will be in contact with the full collection address once the order is ready.
Ready for collection by Friday, 17 May.
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 2 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
South Africa
Product code
Id-9813
Bob Shop ID
607623736
Complete wiring harness for 2 humbucker pickup guitars. Full size pot for volume, push/pull pot for tone (can be used for coil splitting) and high quality 3 way black toggle switch. A black output jack is also connected with ample wire length to accommodate different guitar layouts. There will be wires running to the push pull pot to split your pickups already, you must just connect your pickups to the connecter on the top of the volume pot with a screw driver. If you want to coil split you need to pull the push pull pot. This will only work with pickups that have 4 cord wires.
B500k Volume
A500k Tone with 0.022uf Capacitor (push pull pot)
3 Way Toggle Switch (black with black tip)
Output Jack (black with black nut)
Solderless Connector on top of volume pot (not in the pic)
Wires running from the solderless connector to the push pull pot (not in the pic)
All the necessary nuts and washers