Pre-wired Electronics for 3 Single Coil Strat Style Guitar With Full Size Pots

Name: Pre-wired Electronics for 3 Single Coil Strat Style Guitar With Full Size Pots
SKU: 6470639
Price: 499.00 ZAR
Availability: InStock

4 available / new

Only 4 left – grab it before it’s gone!

R499.00

Add to watchlist Watch

Shipping

R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller allows collection for this item. Buyers will receive the collection address and time once the order is ready.

The seller has indicated that they will usually have this item ready to ship within 2 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

Valley Sound512

100.00 % Positive ratings

Buyer protection

How you're covered

Get it now, pay later

Product details

Condition

New

Location

South Africa

Product code

6470639

Bob Shop ID

620739092

Complete wiring harness for 3 single coil pickup guitars. Full size pot for volume and tone with brass shafts and high quality 5 way switch.

B250k Volume Pot

A250k Tone Pots with 0.047uf Capacitor (Neck and Middle on Tone 1 and Bridge on Tone 2)

5 Way Lever Switch (White tip standard) Black or Ivory tip if mentioned in the order notes.

3 Wires running from the volume pot, 2 go to your output jack and one can be connected to your bridge claw for grounding.

All the necessary screws, nuts and washers for pots and switch.

You need to solder your pickup hot wires to the switch and ground to the volume pot. Volume pot is pre-tinned with solder and so is the lugs on the switch to make for easier soldering. You need to solder the 2 wires that are together to your output jack and the single wire must be soldered to your bridge claw.

Report a problem