Pressure gauge for sand filters (Water saving device)
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 7 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
South Africa
Product code
PG/01
Bob Shop ID
597063394
Quality Pressure gauge 1/4 inch screw-in thread.
Where to use?
- Screw in on the side of your swimming pool's sand filter
SAVE time, WATER and electricity by only doing a backwash-and-rinse ONLY when necessary.
These pressure gauges are installed on the MPV of sandfilters and indicates the operating pressure when the pool pump is working.
For example, let's say after the filtersand or filter media is clean the operating pressure ius about 7 PSI or 50kPa. As dirty and debris clogs up and gather inside the sandfilter, the operating pressure will increase because of restriction of water flow through the pump and system. Increased pressure is thus a indication of dirty sand.