Name: Pro-Tech - Beading Bit 1 1/8 X 1/2 Radius 5/16 1/4 Shank - Pro-Tech - Beading Bit 1 1/8 X ...
SKU: 24207702
Price: 499.00 ZAR
Availability: InStock

Pro-Tech - Beading Bit 1 1/8' X 1/2' ' Radius 5/16' 1/4' Shank - Pro-Tech - Beading Bit 1 1/8' X ...

New

32 available

Indicative market price: R819.00

R499.00

39% off

Shipping

R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller allows collection for this item. Buyers will receive the collection address and time once the order is ready.

The seller has indicated that they will usually have this item ready to ship within 3 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

Toolhome408

84.30 % Positive ratings

Buyer protection

How you're covered

Get it now, pay later

Condition

New

Location

South Africa

Product code

24207702

Bob Shop ID

690234412

Beading bit

Carbide Tipped

Beading bits are similar to the round over profile, but a smaller bearing produces a delicate inset at the base of the cut, giving you an extra decorative option.

Cut a quarter-round shape bounded by fillets, known as a bead, in one pass by this router bit. The width of one fillet is set by the pilot bearing size, while the other is controlled by the depth of cut.

Beading bits create attractive decorative edging that gives a unique finish to the workpiece.

Tip: Cut the ends first and then the sides. Less tear-out is achieved by cutting the end grain first.

This router bit has a6.35 mm shank (shaft) that will fit most small or large routers. Please ensure that you select a router bit with a shank (shaft) size that will fit into your router collet.

PRO-TECH router bits are manufactured in Taiwan.

Features

Features and descriptions for a beading router bit

Specifications

Part No.	Shank dia.	Cutting width	Cutting Height	Radius (r)
KP2803	¹/₄ inch	1 ¹/₈ inch	¹/₂ inch	⁵/₁₆ inch
KP2803	6.35 mm	28.6 mm	12.7 mm	7.94 mm

Length of Shank: 32 mm
Replacement bearing part number: KP100 3-8

Beading router bit

Safety

consider safety for your health and the people around you
General safety suggestions: It is advisable to always have the following items nearby and in a good condition Eye protection clean and scratch free Hearing protection quality earmuffs Dust masks discard old and dirty masks Gloves for easy handling of material and hand protection

Wear Gloves	Eye Protection	Hearing Protection	Dust Mask

To use router bits safely (and to get the best results from your router), the router bits need to be installed properly into the router's collet. Improper installation of your bits can cause excessive chatter and could increase the likelihood that the bits will break when in use.

Clean and sharp

First of all, before beginning any routing operation, check your bits to make sure that they are clean, relatively free of pitch, and most of all, sharp. If the bit is dull, chipped, is excessively burned or has any other defect, it should be sharpened or replaced before use.