Name: Pro-Tech - Pattern Flush Trim Bit. With Shank Mounted Bearing 1/2 X 1 1/4 Shan - Pro-Tech - Pa...
SKU: 18353
Price: 417.00 ZAR
Availability: InStock

Pro-Tech - Pattern Flush Trim Bit. With Shank Mounted Bearing 1/2" X 1" 1/4" Shan - Pro-Tech - Pa...

New

195 available

Indicative market price: R509.00

R417.00

18% off

Shipping

R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller allows collection for this item. Buyers will receive the collection address and time once the order is ready.

The seller has indicated that they will usually have this item ready to ship within 3 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

Toolhome407

84.30 % Positive ratings

Buyer protection

How you're covered

Get it now, pay later

Condition

New

Location

South Africa

Product code

18353

Bob Shop ID

689033472

Pattern Flush Trim bit

Carbide Tipped

These pattern flush trim plunge router bits are versatile, useful for template/pattern routing of parts, joints, and internal cuts and can be used in hand-held and table-mounted routers. They are essentially plunge-cutting straight with shank-mounted pilot ball-bearings.

Excellent for template work!

The template is attached to the work piece, and the pilot bearing rides along its edge as the cutting edges rout the work piece, forming an exact duplicate of the template.

This router bit has a6.35mm shank (shaft) that will fit most small routers. Please ensure that you select a router bit with a shank (shaft) size that will fit into your router collet.

With a hand-held router, the pattern is on top of the work; with a table-mounted router, the pattern is underneath the work. See picture.

PRO-TECH router bits are manufactured in Taiwan. This well-supported and affordable router bit range is a known BRAND in South Africa for over 30 years.

Features

Specifications

Part No.	Shank dia.	Cutting width	Cutting Height	Radius (r)
KP152007	¹/₄ in ( 6.35mm )	¹/₂ in ( 12.7mm )	3/₄-->1 in ( 25.4mm )	Straight

Length of Shank: 32 mm
Replacement bearing part number: KP580061

Flush trim - pattern bit

Safety

consider safety for your health and the people around you
General safety suggestions: It is advisable to always have the following items nearby and in a good condition Eye protection clean and scratch free Hearing protection quality earmuffs Dust masks discard old and dirty masks Gloves for easy handling of material and hand protection

Wear Gloves	Eye Protection	Hearing Protection	Dust Mask

To use router bits safely (and to get the best results from your router), the router bits need to be installed properly into the router's collet. Improper installation of your bits can cause excessive chatter and could increase the likelihood that the bits will break when in use.

Clean and sharp

First of all, before beginning any routing operation, check your bits to make sure that they are clean, relatively free of pitch, and most of all, sharp. If the bit is dull, chipped, is excessively burned or has any other defect, it should be sharpened or replaced before use.