This auction has been won.
View other items offered by Dzignergal43315
Leading
Soft Surf168 1 × R73.00
28 Jun 19:38
Runners-up
Proplus708 1 × R38.00
28 Jun 17:26
haren0073321 1 × R1.00
28 Jun 14:17

Similar products

R30 shipping
Rear Lights LED Light Bar 2USB Power Charger Switch for ATV Can-AM Maverick X3 Polaris Ranger
R517
R30 shipping
Wiring Harness for LED Light bar with Remote
R474
R30 shipping
CHINT NP2-BW3463/220V 2 NO Pushbutton Switches With LED Light Silver Alloy Contact Push Button
R252.78
SMD Selica white LED Push in Bulbs
R96

Push White LED Light Bar Switch For Toyota

1 was available / new
R73.00 auction closed
R299.95
Shipping
Standard courier shipping from R60
R60 Standard shipping applies to orders under R100, in most areas in South Africa. R30 Standard shipping applies to orders over R100. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item ready to ship within 3 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:
 
Standard Delivery
Main centres:  1-3 business days
Regional areas: 3-4 business days
Remote areas: 3-5 business days
Buyer Protection How you're covered
Get it now, pay later

Product information

Condition:
New
Location:
South Africa
Customer ratings:
Product code:
toyota
Bob Shop ID:
235096172

 

 
 

  

Material: Plastic

LED Light Color:White
Black hard surface rocker.
Laser etched Legend.
Rated at 3Amp 12V.
High quality single pole single throw ON-OFF push switch.
Face surface size: 39 mm x 21 mm
Uses the original mounting hole of the vehicle.
Switch cutout required for the other accessories is about 17mm x 36 mm.
These switches are an aftermarket switch that locks into your existing panel
super easy to install in less than 10 min's.
All symbols are Laser etched directly onto the switch face using modern high Tech
laser engraving equipment to ensure long image life.
Wiring diagram:
Red wires should be connected to battery +,
Black wire should be connected to battery -,
Green wire should be connected to load +(load- connected to the battery -),
Blue wire can be connected to battery + or not connected(You have the different choice based on yourself).
Package Contents:
1x Push Switch
1x Wire
 
 
 

 

 

Customer ratings: 1 ratings

¿¿¿¿
21 Jul 2016