R230 Automatic Voltage Regulator Electronics Module Card Genset Parts
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Returns
Product information
Condition:
New
Location:
International
Bob Shop ID:
613487293
The regulator monitors the exciter excitation current as a function of the alternator output voltage.Very simple in design,the alternator with shunt excitation has no sustaining short-circuit capacity.Voltage Regulation:around +/- 0.5; Voltage supply/sensing range 85 -139 V (50-60Hz)Rapid response time (500 ms) for a transient voltage variation amplitude of 20Voltage setting P1; Stability setting P2.Initial potentiometer settings :1) P1 potentiometer (AVR voltage adjustment): fully anti-clockwise.2) Remote voltage adjustment potentiometer: centre position.Run the alternator at its rated speed. If the voltage does notincrease, the magnetic circuit should be remagnetized (seesection 2.3)3) Turn the AVR voltage adjustment potentiometer P1 slowlyuntil the output voltage rated value is obtained.4) Adjust the stability setting using P2.5) Sealed potentiometer P3 is factory set at 48 Hz for 50 Hzand 58 Hz for 60 HzMaterial: plasticcolour: blackPackage Contents:1 x Automatic Voltage RegulatorOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.