Rack End for Chrysler Voyager IV RG RS (2000-2008) - CR1410

Vehicle Fitment & Part Details

This rack end fits the Chrysler Voyager IV (chassis RG and RS), with OE cross-reference 4743935AD and a 310 mm overall length. The rack end threads into the steering rack and carries the ball joint that connects to the outer tie rod end. Confirm compatibility by matching the listed fitment details and any OEM reference numbers supplied. Verify VIN/engine.

Key Details

SKU

CR1410

Component

Rack End

Primary Fitment

Chrysler Voyager IV RG / RS (2000-2008)

Specs

310 mm length, M14x1.5 thread at both ends, fits at tie rod

Key Benefits

• Cross-referenced to six Chrysler OE numbers (4743935AD, 68019643AB, 68019642AA and more) for accurate matching before ordering.
• 310 mm overall length with matched M14x1.5 threads at both ends, matching the supplied specification for the Voyager IV steering rack.
• Covers all supplied Voyager IV petrol and diesel engine variants including 2WD and AWD models.

OEM Reference Numbers

• Chrysler: 4743935AD, 68019642AA, 68019642AB, 68019643AA, 68019643AB, 68072215AA

Product Specifications

Vehicle Fitment

Fitment Notes

• Always match OEM reference number(s) and vehicle details before ordering. Verify VIN/engine.
• Engine specification does not affect rack end fitment - the same part fits all supplied Voyager IV petrol and diesel variants including 2WD and AWD models.
• The rack end is the inner steering link that threads into the steering rack. It is different from the outer tie rod end which threads onto this component and connects to the steering knuckle.

Installation / Use / Maintenance Tips

• Compare the new rack end to the removed unit before installation to confirm length, thread size, and ball-joint orientation match.
• Inspect the steering rack boot, outer tie rod end, ball joint boot, and mounting hardware before fitting the new rack end.
• Clean the threads in the steering rack and use the correct orientation and thread-locking compound where specified by the workshop procedure.
• Replace the steering rack boot and any damaged clips during installation.
• After installation, confirm wheel alignment is checked and adjusted before road use - steering geometry is affected by rack end replacement.

Common Questions

Will this rack end fit my Chrysler Voyager IV?
This part (CR1410) is listed for the fitments shown on this page. Confirm by matching the fitment details. Verify VIN/engine.

What OEM part numbers does this cross-reference?
Cross-reference numbers are listed in the OEM Reference Numbers section above. Match at least one to your original part before ordering.

Is this the same as a tie rod end?
No. The rack end is the inner component that threads into the steering rack and carries the ball joint. The tie rod end (also called the outer tie rod) threads onto the rack end and connects to the steering knuckle at the wheel. Both parts can wear and are often replaced together, but they are not interchangeable.

Do I need wheel alignment after installation?
Yes. Replacing a rack end changes the effective length of the steering linkage. A four-wheel alignment is required after installation before the vehicle is returned to road use.

How do I confirm fitment if there are multiple variants?
Compare the supplied fitment details to your vehicle. Verify VIN/engine. If unsure, request fitment assistance before ordering.