R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable. Check my rate
The seller has indicated that they will usually have this item
ready to ship within 12 business days.
Shipping time depends on your delivery address.
The most accurate delivery time will be calculated at checkout,
but in general, the following shipping times apply:
Replacement Guarantee:
7 Days: We stand by this guarantee
Get it now, pay later
Product details
Condition
New
Location
International
Bob Shop ID
643263521
Built-in super bright red lens LED brake light provides added safety when your hitch is not in useLamp size: 3-1\/4 x 3-1\/4 inches to fit 2inch standard tow hitch and function as tail brake light or rear fog light with strobe flashing featureComes with a hitch pin with lock and foam lining to a snug fitUnlike other 9-LED hitch mounted LED brake light with bright mode only, our 15-LED features a bright brake light, which will not blink along with your turn signals, AND a dimmer running tail light!Installation Tip: when you plug in this adapter, pay attention to the orientation. Push in the adapter from an angle starting from the pin in the red (see picture 4 and also video). If you have difficulty install the adapter, you can always bend the pins slightly during the plugging process.FAQ:Q: Why does the LED brake light fits the tow hitch, but feels loose?A: The tow hitch cover is only secured by the tow hitch lock to make sure that it does not fall off, so the lock is not completely tight. There is already some foam in the inner side of the tow hitch cover, but if you feel that you would like the tow hitch cover to fit more snug, you can always add some foam to hold the tow hitch cover in place.Q: What if the LED brake light wiring is not long enough for my vehicle?A: The length of the wire for the LED brake light is designed to work for most trucks and SUVs with tow hitch. In some rare cases if the wiring is too short, you can extend the wires. Cut the adapter wires and extend the wiring.Q: Why does the LED brake light not light up after I plugged in the adapter?A: In some rare cases, the vehicle's positive\/negative are reversed. The LED assembly is sensitive, the polarity reverse causes LED to not light up. This is rare, but can be fixed. Take the adapter and cut the wires. Flip the wires to reverse the ity.Material:metalcolour:RedPackage Contents:1 x 2inch WITH 15 LED brake light(Hitch Pin is Included)1 x 16 AWG x 2C x 10inch wire with flat trailer connectorOnly the above package content, other products are not included.Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +\/- 1-3cm.