Red YT-160A Double Head Sheet Metal Nibbler Cutter Drill Attachment Metal Sheet Cutter for Electric

New

20 available

R681.00

Shipping

R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller has indicated that they will usually have this item ready to ship within 12 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

szulou3915

92.60 % Positive ratings

Buyer protection

How you're covered

Returns

Replacement Guarantee: 7 Days: We stand by this guarantee

Get it now, pay later

Condition

New

Location

International

Bob Shop ID

651235784

Description:
Red YT-160A Double Head Sheet Metal Nibbler Cutter Drill Attachment Metal Sheet Cutter for Electric Drill

Specification:
Fit For Electric Drill
Color: Red
Model:YT-160A Material : Metal, Plastic Color : Black, Silver Tone Cutting Diameter : 7.4mm / 0.3 Handle Diameter : 33mm Overall Size : 18 x 5.0 x 7.6cm / 7 x 2 x 3 (L*W*H) Suitable for car repair and maintenance and metal sheet productions.
Allow Cutting Thickness: Ordinary iron plate: 1.8mm Stainless steel plate: 1.2mm Copper, aluminum plate: 2mm Plastic plywood car: 2mm Features: -There are two cutter heads for adjustable head cutting. -The cutter head can be positioned 360 degrees in any direction. -Optional 8mm electric or pneumatic drill, speed 1500-3000 rev / min. Instructions: 1.When using the thin plate hole opener, first insert the drill front end and the cutter into the round hole of the hole opener, connect the cutter to the electric drill and lock it tightly, then put the three branches on the shelf and the stud screws tightly. In order to prevent the hole opener from sliding; insert the left and right positioning pins upward into the small square hole of the shelf, and finally adjust and tighten the tight screw according to the size of the arc to be cut, and fix the ruler Prison to ensure the accuracy of cutting round holes. 2.When cutting a standard arc, a thin-plate hole opener should be used to ensure that the circular cut surface is smooth and beautiful. It should also be drilled with a 3 mm positioning eye first, and then drill a 12 mm hole to extend the cutter head into the hole. Cut the inner and outer circles. Operational Requirements: 1.It is especially important to cut the aluminum plate at the blade edge. 2.After the electric drill is first opened, the electric drill is turned off after the end of the cutting. 3.The cutting edge of the cutter bar must be perpendicular to the workpiece to be cut during cutting to prevent the hard head from breaking the cutter head. Package Included: 1 x Metal Nibbler Cutter 1 x Allen Wrench
More Details: