Replacement LED Floodlight COB Chip | Flood Light Repair | Cool White 6000K | 6-12 Volt DC

Replacement LED Floodlight COB Chip | Flood Light Repair | Cool White 6000K

Please NOTE that the LED Power Supply / Driver must be 6 Volt to 12 Volt. Exceeding these voltages may damage the LED Light and not covered under warranty or constant LED flickering will be experienced on higher voltages than supported 6v-12v range.

How to Repair a LED Floodlight / Spotlight ?

Most LED Floodlights / Spotlights are basic units with only a power converter (LED Driver or DC Power Supply) that converts from 220 Volt to 6-12V DC and the LED Light (Also called LED COB (Chip on Board) or LED Reflector)

COB(Chip On Board) LED flood lights chips is composed by many small size LED chips. On most LED Floodlights one of these 2 components fail and really easy to repair than buying a new complete floodlight. Repair takes about 5-10 minutes. 

Dimensions of COB LED Light : 40mm x 40mm

You will need tools below to repair a LED Floodlight

• Philips Screwdriver (Star Point Screwdriver) or Flat Screwdriver depending on screws used by casing on LED Floodlight
• Soldering Iron optional to ensure wires are securely connected (Otherwise it can just be tied to LED Light Frame)
• If the LED Driver (Power Converter) has failed and needs to be removed you will need Pliers to remove the power converter since it is attached to the casing mostly by using silicon.
• If the LED Driver (Power Converter) has failed you need optional double sided tape or silicon to secure the new power converter against the casing.
• Thermal Paste (Thermal Compound) which can be purchased from any PC retailer also used for PC CPU Heatsinks etc will be needed to ensure the COB Light can transfer heat to the casing and do not overheat. NOTE!!! If Thermal paste not used a LED Light will overheat and heats within a few seconds of usage. Incorrectly installed / overheated COB Lights will not be replaced as per Terms & Conditions.

Instructional Video to Repair LED Floodlights below

?v=o94Clh3ovnA

?v=_4xI0AdYlzQ

This LED COB Chip can be used to repair most LED Floodlights as below having a LED Chip size of 40mm x 40mm.

Please NOTE LED Power Supply / Driver must be 6 Volt to 12 Volt!! Exceeding this may damage the LED Light and not covered under warranty or constant flickering will be experienced on higher voltages than supported 6v-12v