Replacement pilot drill bit for 915 series tct hole saws
New
Shipping
Standard courier shipping from R60
R60 Standard shipping applies to orders under R100, in most areas in South Africa. R30 Standard shipping applies to orders over R100. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 3 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
South Africa
Product code
TC00003
Bob Shop ID
616068530
Pilot drill bit for hole saws
Drill bit diameter: 6.35mm
Drill bit: TCT (Tungsten Carbide Tipped)
Application:
The drill bit is a replacement pilot drill bit for Tungsten Carbide Tipped (TCT) hole saws.
Replacing the pilot drill bit:
- Use an Allen key (TC17016) or in some cases a slot-head screwdriver to undo the grub screw securing the pilot drill bit in the mandrel.
- Replace the pilot drill bit by aligning the flat side on the shank with the grub screw.
- Tighten the grub screw. Make sure the pilot drill bit is secured.
- In some cases it would be necessary to remove the hole saw from the mandrel to replace the pilot drill bit.
Mandrel replacement pilot drill bits:
- 6.35 x 115mm (extra long) for bi-metal hole saws -TC00001
- 6.35 x 70mm for bi-metal hole saws -TC00002
- Tungsten Carbide Tipped (TCT) series hole saws -TC00003
- Carbide grit hole saws -TC00004
- Diamond coated hole saws -TC00006