S3213 Outboard Marine Fuel Filter Elements Fuel Water Separator
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
613498072
Application: Outboard engine for Yamaha Mercury Honda speedboats Motorboats, etc.The o-ring does not compress and allow the filter to Press the housing, which then creates a leak. The O-rings are excellent quality.Draining of water or replacement of elements is determined by contamination level of fuel. Inspect the collection bowl for water daily and service as necessary. Replace elements at least once a year or when a decrease of power is noticed.color: Whitematerial: metalTo Drain Water1. Loosen self-venting drain plug to drain water from bowl into a container.2. Tighten drain.3. Use primer bulb to fill filter with fuel.4. Start engine and check ensure there are no leaks.Category: Oil-water separatorFiltration accuracy:10 MICRONThread Type / Size: Mercury Thread 11/16 inch 16 T.P.IModel number: S3213Size:Height: 102mmOD/Width Max: 96mmOD/Width Min: 93mmID/Depth Max: 81mmID/Depth Min: 16mmApplication: Mercury / Quicksilver / OMC outboard engineInterchangeable With: 35-60494-1Package Contents:2 x Fuel Water SeparatorOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.