SATA3.0 6Gbps JMB575 Chip SATA Expansion Card 1 to 5 Port Riser Card
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
TBD0603731601
Bob Shop ID
595736957
Feature:
1. Supports 6-port 6.0Gbps SATA III interface
2. Output swing control and automatic impedance calibration for SATA III PHY.
3. Supports asynchronous signal recovery.
4. Supports spread spectrum clocking.
5. Supports partial / slumber power saving mode.
6. Automatically speed negotiation.
7. Supports BIST and loopback mode.
8. Supports staggered spin-up (Optional).
9. Supports Hot-Plug.
10. Supports asynchronous notification.
11. Supports ATAPI drives.
12. Supports command-based and FIS-based swit.
Specification:
Product name: SATA3.0 1 to 5 expansion card
Product master: JMICRON JMB575
Product interface: SATA 7PIN
Support system: for WINXP, WIN7, WIN8, WIN10
Warm Tips:
1. This extension card must support the PM (SATA PORT MULTIPLIER) function of the motherboard or the extension card to recognize 5 hard disks.
2. The main motherboard SATA does not support this function. If it is not supported, only one card can be recognized.
3. You must plug in the SATA or DC2.5 power supply to the expansion card.
Include:
1 x SATA Expansion Card
1 x USB-DC Power Cable
1. Supports 6-port 6.0Gbps SATA III interface
2. Output swing control and automatic impedance calibration for SATA III PHY.
3. Supports asynchronous signal recovery.
4. Supports spread spectrum clocking.
5. Supports partial / slumber power saving mode.
6. Automatically speed negotiation.
7. Supports BIST and loopback mode.
8. Supports staggered spin-up (Optional).
9. Supports Hot-Plug.
10. Supports asynchronous notification.
11. Supports ATAPI drives.
12. Supports command-based and FIS-based swit.
Specification:
Product name: SATA3.0 1 to 5 expansion card
Product master: JMICRON JMB575
Product interface: SATA 7PIN
Support system: for WINXP, WIN7, WIN8, WIN10
Warm Tips:
1. This extension card must support the PM (SATA PORT MULTIPLIER) function of the motherboard or the extension card to recognize 5 hard disks.
2. The main motherboard SATA does not support this function. If it is not supported, only one card can be recognized.
3. You must plug in the SATA or DC2.5 power supply to the expansion card.
Include:
1 x SATA Expansion Card
1 x USB-DC Power Cable