Servo Driver HAT for Raspberry Pi, 16-Channel, 12-bit, I2C

Servo Driver HAT for Raspberry Pi, 16-Channel, 12-bit, I2C

3 available / new
Indicative market price: R368.64
Only 3 left – grab it before it’s gone!
R335.13
Shipping
R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate
The seller has indicated that they will usually have this item ready to ship within 2 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:
 
Standard Delivery
Main centres:  1-3 business days
Regional areas: 3-4 business days
Remote areas: 3-5 business days
Seller
Buyer protection
Get it now, pay later

Product details

Condition
New
Location
South Africa
Product code
3376
Bob Shop ID
613701789

Needless to say, the Raspberry Pi is powerful enough in most cases, yet it's not that good at providing precise PWM output. You may have tried to control a robotic arm or a hexapod walker by using the Pi, but finally get frustrated due to the limited number of PWM outputs and the jittering servo. Now you get a new option to bring your ideas to life, we prepare this useful Servo Driver HAT for you.

Features

  • Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano
  • I2C controlled, using only 2 pins
  • Up to 16-Channel servo/PWM outputs, 12-bit resolution for each channel (4096 scales)
  • Integrates 5V regulator, up to 3A output current, can be powered from battery through VIN terminal
  • Standard servo interface, supports common used servos
  • Reserved I2C control pins, allows to work with other control boards
  • Comes with development resources and manual (examples in python like Bluetooth/WiFi remote control)

Specifications

  • Power supply: 5V (Pi connector) OR 6V~12V (VIN terminal)
  • Servo voltage: 5V
  • Logic voltage: 3.3V
  • Driver: PCA9685
  • Control interface: I2C
  • Dimension: 65mm x 30mm
  • Mounting hole size: 3.0mm

Dimensions

What's in the box?

1 x Servo Driver HAT

1 x RPi screws pack (2pcs)

Resources

Wiki : www.waveshare.com/wiki/Servo_Driver_HAT

Note: Stock is currently available in South Africa for national shipping!
Add to cart

Recently viewed

See more
Computers software and information disks and manuals
R130.90
WiFi + Bluetooth ESP32 Development Board
R195.00
50% OFF
Yongnuo RF-600TX Wireless Controller + RF-602RX Wireless Flash Trigger + RF-602RX Flash Trigger
R1,000.00 R2,000.00
7% OFF
OWC 4GB DDR3 1066MHz Memory Module
R270.00 R290.00

Similar products

Waveshare 4G / 3G / 2G / GSM / GPRS / GNSS HAT for Raspberry Pi, LTE CAT4, for China
R1,422.00
Decoder tone demodulator dip14 xr2211cp
R53.09
9% OFF
Argon IR Remote for Argon ONE V2 and the V3 M.2 NVME PCIE Case
R201.73 R221.90
Ic codec filter cmos soic16 tp3057wm
R32.14