This item has closed 2 buyers bought 2 items
View other items offered by Solarsec171

Similar products

50W Solar Panel Portable Flexible Monocrystalline Solar Kit W/ 10A/30A/60A/100A Co... (CURRENT: 30A)
R744.00
4% OFF
555W JA: 555W Deep Blue 3.0 Mono
R2,692.40 R2,794.00
30% OFF
Solar Flood Light 30W (Fussion 65021-30) including Solar Panel & Remote
R279.00 R399.00
5mm clear yellow 2k5 20a 30-deg 588-595nm 210202
R1.24
SETSOLAR 0-30A (Auto Sense)
Sold

SETSOLAR 0-30A (Auto Sense)

9 were available / new
Indicative market price: R800.00
R295.00
63% off
Shipping
R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate
The seller has indicated that they will usually have this item ready to ship within 3 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:
 
Standard Delivery
Main centres:  1-3 business days
Regional areas: 3-4 business days
Remote areas: 3-5 business days
Buyer protection
Returns
Warranty Type: Replacement 30 days Replacement Guarantee: 7 Days: Must be returned in original packaging
Get it now, pay later

Product details

Condition
New
Location
South Africa
Product code
Reg 30
Bob Shop ID
103655500

 

 

 

The SETSOLAR 0-30A (Auto Sense) regulator protects batteries from over charging
and draining.


The regulator is equipped with a switch which connects the solar panels to the battery
when not fully charged. The regulator also has a switch on board which can
disconnect a load preventing the battery from discharging any further.
The regulator automatically selects which battery bank is connected. It does this every
time it is connected. Possible battery banks: 12 / 24 / 36V
Note: the regulator only performs the selection at start-up.
This means it is possible to re-use a regulator, which was used in a 12V system into a
24/36V system.


Switch moment voltages:
Battery: 12V system
Panel gets disconnected at: 14.8V
Panel gets connected again at: 13.8V
Load gets disconnected at: 11.8V
Load gets connected again at: 13.2V
Note: for the other battery bank voltages 24/36 multiply the above voltages by
resp. 2,3,4.


Switch delay:
To prevent damage to the switches in case weak batteries are connected to the
regulator, a switch delay is activated after a switch has changed position. This
prevents the switch for about 20 seconds to change position again.


LED indication:
A coloured LED indicates the status of the regulator:
1) RED flashing fast: The battery voltage is low. The load is disconnected.
2) Orange flashing slow: Both the load and the panel is connected to the battery.
3) Green flashing fast: The battery is full. The panel is disconnected from the battery.
Note on 36V systems:
For the auto selection of the battery bank to work properly make sure that when
connecting the regulator to a 36V system the bank voltage is above

Recently viewed

See more
50% OFF
Viecar VP004 Car Mini OBD + USB / Type-C Interface Fault Detector V1.5 WiFi Diagnostic Tool
R654.00 R1,308.00
Jenfit Coupling Compression Reducing Tn 40 X25 Mm
R102.34
50% OFF
Action Mounts Quick Release Tripod Mount Adapter Bracket for GoPro Hero 3 x2 Combo
R129.00 R258.00
61% OFF
1 Tree Of Life Tapestry With Diamonds
R588.00 R1,526.00